In order to get the AMB decoder working with the BMI-Leisure Timing system, the device(s) need to be able to communicate with each other. The following steps will guide you through the process.
- Press the arrow button to go into settings.
- navigate to network with the arrow button and confirm with the dot button
- Make sure the “Automatic option” is off.
- navigate to IP address with the arrow button and confirm with the dot button
- configure the IP address.
- use the arrow button to move position
- use the dot button to increase the number. (number will reset after reaching maximum)
- save the IP address
- navigate to “subnet mask” with the arrow button and confirm with the dot button
- configure the “subnet mask”.
- use the arrow button to move position
- use the dot button to increase the number. (number will reset after reaching maximum)
- save the “subnet mask”
- navigate to “gateway” with the arrow button and confirm with the dot button
- configure the “gateway”.
- use the arrow button to move position
- use the dot button to increase the number. (number will reset after reaching maximum)
- save the “gateway”
- exit settings
- restart the decoder
- restart the BMI-Leisure Reader module
If you have issues, our support team will help you.